2 Killed in Wrong-Way DUI Crash on SR-163 #local #news, #san #diego


#

2 Killed in Wrong-Way DUI Crash on SR-163

Two people were killed in a wrong way crash on northbound SR-163 in Mission Valley on May 16, 2015. NBC 7’s Diana Guevara reports. (Published Saturday, May 16, 2015)

Two people were killed early Saturday morning along northbound State Route 163 in a head-on crash with a DUI suspect driving the wrong way, officials confirmed.

The deadly collision happened just after 1:30 a.m. on SR-163 right underneath the Interstate 8 overpass in the Mission Valley area.

According to the California Highway Patrol, a man driving a white pickup truck was flashing his hazard lights while driving the wrong way on the freeway. That driver plowed into a Toyota Prius, totaling the car and killing two of the five people inside.

Officials said at least one person was left trapped but alive inside the Prius. The driver of the truck was also stuck and emergency crews had to pry all of the victims out of the wrecked vehicles.

2 Killed in Wrong-Way Freeway Crash

California Highway Patrol said two people died at the scene and three others suffered major injuries. The survivors were taken to a local hospital.

The crash remains under investigation. CHP shut down traffic in the area for many hours as crews rescued victims, cleared the accident and gathered evidence.

On Saturday afternoon, CHP officials confirmed the driver of the truck had been arrested on suspicion of driving under the influence. His name was not released.

Bystander Ron Bryson was traveling down SR-163 and witnessed the aftermath of the collision. He said it was utter chaos on the freeway.

In the white truck, there was one drive in there. He was trapped. He got hit by the airbag and he was hanging into the passenger seat, Bryson described. The car in the front the gentleman was lying on the ground. There was an SUV ahead of them, so there were probably about three cars involved.

Bryson said it looked like the front end of the Prius had been completely ripped off, with debris strewn all over the road.

The names of the victims killed in the crash were not immediately released.

According to the San Diego County Medical Examiner’s Office, the victims were both young women, ages 24 and 23. One victim was a La Jolla resident and the other was a resident of Mission Viejo, Calif.

This is the second fatal wrong-way collision on a San Diego freeway in just two weeks. On May 2, DUI suspect Shane McDonald drove the wrong way on southbound Interstate 15 noth of Mira Mesa Blvd. slamming head-on into a car carrying a family of five. Two people in that family car were killed, 55-year-old Rodolfo De la Torre and 84-year-old Teresa Esparza Hernandez.

Published at 10:43 AM PDT on May 16, 2015 | Updated at 5:43 PM PDT on May 16, 2015


Pex Repiping #los #angeles #repipe, #los #angeles #repiping, #long #beach #repipe, #long


#

PEX REPIPE SPECIALIST

Uponor Pex Repipe – The World’s First, Best, And Most Widely Used System For Single Family Homes And Residential Units.

What is PEX?

PEX is an acronym for crosslinked polyethylene. It is a flexible, durable, proven piping product that has been used in plumbing systems for more than 20 years. PEX tubing won’t pit, scale or corrode and, because of its flexibility, it also offers potential freeze-damage protection.

Residential Commercial Pex Plumbing. Call Toll Free 877-473-7473

Uponor Pex plumbing systems feature PEX-a tubing, which is considered the superior PEX tubing manufacturing method in the industry. PEX-a is the most flexible of all PEX types, and because of its shape and thermal memory, it can use ProPEX expansion fittings which are the only fitting system that actually gets stronger over time – making it highly leak resistant.

1) Repiping in a home begins at the transition point.

2) The transition point is the point where the potable water system enters the building from the exterior of the building.

3) Repiping a potable water system means you totally abandon the existing potable system and replace it with a new system.

4) The first step in repiping your home is masking or “covering” the floors, and this must be completed before the walls are masked off. This overlap “ enveloped ” system allows the plastic sheeting to be rolled up in one continuous motion.

5) Cutting the sheetrock: You will be shocked at how little sheetrock has to be removed for the layout and installation of a new potable water system. A real Pex Plumber is an expert at HVAC, framing, plumbing, and electrical layout, and will lay out the home pex repipe in the most effective route. The better the repiper. the smaller and fewer the drywall holes!

6) A “GREEN REPIPE” potable water system refers to a Pex repipe potable system only – such as UPONOR or ZURN with corrosion resistant fittings. CPVC and copper systems are not green systems.

7) The drywall pieces that are removed must be used in the patching process as each texture is a little different in thickness. This gives you a uniform surface thickness as you start the repair process. Each piece goes back in the hole it came from.

8) Repipe with an approved material. There are currently three main materials used in pex repiping jobs across the US: copper pipe and fittings, CPVC pipe and fittings, and PEX repipe and fittings. (DO NOT USE CPVC, IT IS THE NEXT POLYBUTYLENE)

9) Repipe inspections must be performed by the local building inspectors after the repipe is completed, with the system under full water pressure.

10) The signed inspection card must be given to the homeowner after the PEX repipe inspection is completed.

11) Drywall repair begins after all the necessary backing has been installed. Backing supports the drywall pieces that were removed to access the potable water pipes and accommodate the repiping of a new Pex repipe or copper potable water system.

12) The fiberglass mesh tape must be used 100% of the time.

13) The patches must be pre-filled with quick set patching compound. The compound comes in 18lb bags, and because it is a powder, it must be mixed with water. This locks the perimeter of each patch and will make the area of the patch stronger than it was before the work process began. The reason this is important is that when you close the doors in the house, the walls flex just a little bit, and if you do not perform this method of repair, the patch will fracture over time from the flex/vibration caused by shutting the doors.

14) Do not coat the drywall patches with regular all-purpose joint compound on the repipe patches.This is a common practice and the patches will crack later 100% of the time, even if it’s years later.

15) Coat all the repipe drywall patches with quick set patching compound only. USG will do and you can find it at any home and hardware store, or you will have fractures in the walls at the patch locations.

16) Float all the walls with quick set patching compound and use a 12″ drywall knife and stagger each coat until the walls become smooth and flat. The next step is wet sanding the patches and this must be done if you want the patches to blend in perfectly after the texture is applied. The reason you’ve seen bad patches in the past is that repairmen do not know how to “kill the edges.” This is an old drywall term that means you must do the detail wet sanding work and there is no short cut.

17) Texture to match the existing texture, and this is not as easy as you might think. This is a real art form for the few that know what they are doing. Also, if the texture is spray texture, you must sponge off the overspray for the texture to match. Nothing gives away the location of a patch more than overspray that is painted over and not “killing the edges.”

18) Paint to match the existing paint. All repipe companies color match the same way. They run down to their local hardware store and have the computer color matching done by the man behind the counter. This is beginner color matching. The proper way to color match is hand color matching. First, match the paint sheen. Second, computer match for the base color. Third, tint for color adjustment. Fourth, match the color and sheen after the paint sample has dried. Repeat if necessary. Did you know that the paint color on the wall after it dries will be different than the paint color while it is wet and in the can?

19) If you follow the basic repiping rules, after a very short time you will not be able to point out all the drywall patches from the repair. You will simply forget where the holes were due to the patches receiving the proper floating, texture and painting techniques. Your friends, neighbors, relatives, and even plumbing contractors will not be able to find the patches.

20) This is a basic guideline for a home repipe. and if done, properly you will have a repipe that was done as well as a repipe can be done.

At Integrity Repipe. we provide total abandonment of your existing potable system, and there are never hidden extras, and we don’t hire subcontractors. You’ll receive nothing but the finest, most complete and professional job in the industry. The scope will be for a lead-free and yellow brass -free potable “GREEN SYSTEM” with a full lifetime warranty that covers material and labor.

Contact Your Local Burbank Repiping Company


Hotel Chula Vista CA, Lodging San Diego California #edmonton #motels

#motels in san diego

#

Palomar Inn Lodge in Chula Vista CA is preferred by visitors looking for Hotel Chula Vista California, Chula Vista Hotel CA, Hotel Chula Vista, Hotels Chula Vista, Hotel Inn Chula Vista, Motels Chula Vista, Motel Chula Vista, Motel Chula Vista CA.

Palomar Inn is the choice for San Diego Hotel California for San Diego beach Hotel CA, Hotel Chula Vista San Diego, San Diego Hotel, San Diego Inn, San Diego Accommodation, San Diego Motel, San Diego Hotels, San Diego Motels, San Diego nearby Hotel, Hotel near San Diego.

3 Mile(s) from Imperial Beach, San Diego

5 mile(s) from Cricket Wireless Amphitheatre, concerts in Chula Vista

6 mile(s) from Soak City, water park in Chula Vista

8 Miles from San Diego Convention Center

9 mile(s) from San Diego Zoo. located in Balboa Park

10 Miles from ARCO Olympic Training Center in Chula Vista

10 mile(s) from San Diego Balboa Park, 13 museums

11 mile(s) from San Diego Seaport Village, 75 shops and restaurants

13 mile(s) from San Diego Seaworld

Guest Room Amenities in All Rooms/Suites.

32 High Definition flat panel Samsung T.V. in every room.

Work Desk with Lamp Desk Level Electrical Outlets.

Refrigerator / Microwave / Steam Iron and full-size ironing board / Hairdryer

Coffee/tea maker with Premium Classic Coffee Condiments in every room suite

Spare Electrical Outlet at Desk in all the rooms and suites.

Premium High Definition cable channels with three movie channels.

Guaranteed Non-Smoking Spacious Rooms/Suites

Air-Conditioning with Heating and Cooling