Replacing the final stage unit # #replacing #the #final #stage #unit/blower #motor


#

Does your A/C-heater blower seem like it’s possessed? Does it quit working for no apparent reason, then come on again just as mysteriously? Does it run only at one speed no matter what the controls say? Does it keep running even when the car is off and the key is out of the ignition? Your problem is most likely a faulty final stage unit.

Based on what I’ve seen here and elsewhere, this is a chronic problem with the E39, but fortunately it’s a relatively cheap and easy fix. There’s a good DIY here. but since questions about it get posted here with regular frequency, I figured it would be a good idea to post one here too. Some of the photos in this post are very large because it’s very helpful to see the details if you have no idea what’s going on here.

BMW calls this thing the “final stage unit;” the parts guys call it a “blower motor resistor.” I’m not sure what the reason for the different terminology is, but it’s the same part. The PNs have changed a couple of times over the years, but as of the date of this posting, what you want is PN 64 11 6 923 204 and there’s a diagram of the system here. As far as I can tell, the same part is used in all E39 models (but you may want to confirm this). Bavarian Autosport has them for about $70, but they’re unfortunately available a lot of places, including the parts counter of your local dealership (I say “unfortunately” because it’s a reflection of how often this thing fails).

For some reason, dealer service departments are notorious for not being able to recognize this issue, and may charge you for hundreds or thousands of dollars of unnecessary repairs without solving the problem. If you don’t feel confident doing this yourself (i.e. you’re the sort of person who is more likely to take an eye out with a screwdriver than a screw), at least bring them this information. Done properly, this is a 15-minute,

This is what you’re replacing:

The silver part of it is a heat sink. I’m not an electrical engineer, but I believe this thing allows the blower controls to change the speed of the blower by altering the current that passes through it. Inside is a bundle of resistors, and by sending the current through a different combination of leads, it creates the proper current to operate the blower at a desired speed. But resistors generate heat (thus the need for a heat sink), and over time, I suspect the constant heat up-cool down cycle degrades the resistors until they no longer produce the right current, and the controller can no longer send the right signals to the blower. Thus, the blower starts acting strangely despite what the controls are doing.

Now, I’ve read a lot of horror stories about how difficult this replacement can be, but I didn’t find it that way at all. This is an extremely simple operation that took me less than 10 minutes. The hardest part was getting myself into a position where I could get at the faulty FSU.

All you need here is a Phillips screwdriver, a flashlight (the one in your glovebox will work fine) and understanding that you’re working with electrical components, not mechanical ones. That means being mindful of how much force you’re using. Nothing in this operation requires any great effort, so if you find yourself needing force things, you’re doing something wrong.

The FSU is behind the dash in the passenger side footwell. You’ll find it easier to work if you pull out the cover under the glovebox. It’s not secured by anything, so just yank it out. The FSU is behind a fabric covered plastic panel on the left side:

You want to unscrew the screw (red circle), then slide the panel backward (see arrow), not out. It’s also held in place by two metal clips that attach to the frame behind it:

Once you’ve got the panel out, lay on your back and look up at the space you’ve just exposed. The FSU is inside there.

Inside the space, you’ll see a plug with 5 colored wires coming out of it. The FSU is the thing the plug is connected to, so you’ve got to get the plug out. The plug is held in place by two clips on the side, and you need to squeeze the clips to free it.

You may find the plug a bit difficult to get out; if so, just wiggle it back and forth until it comes free. Don’t yank it out–you may break one of the wires loose, in which case you’ve just bought yourself an expensive and embarrassing trip to the dealer.

The FSU is itself held in place by another clip at the bottom. You need to push this clip down at the same time you’re pulling the FSU out.

Again, if you’re doing it right, you should not need to force anything. Once free of the clip, the FSU should slide out easily.

You may find all of this easier if you lay on your back in the footwell to get your bearings, then sit up straight, reach under the dash, and do it “by feel.”

Now, surprise, surprise, the part you’ve just removed won’t resemble the new one exactly, since as I mentioned, the PNs have changed a couple of times:

Hmm, could this be because the original version was defective?

Now just slide the new one in the spot the old one came out of. It should slide into place with a “snap” as the clip engages it.

New FSU in place. Note orientation–it will only go in one way. If you’re having trouble getting it in, you’ve probably got it rotated 90 or 180 degrees out of alignment.

Replace the plug, then slide the panel back in the way it came out. Be sure to get both clips into their respective slots, or it will hang loose. Replace the screw.

If you’ve done everything right, your blower should operate normally now. If it’s not, go back in and check the connections. If everything looks right but it still doesn’t work, you may have other problems.

Thank’s for the instructions, my wife has a 2003 530i with 54K miles and her blower stopped working entirely. Here’s a little story.

The A/C stopped blowing air and I hadn’t gotten the BMW manual for it yet so I took it in to the dealership and I figured it would probably just be a simple electrical relay .
They called my wife back telling her ;

1) $440 to fix the blower,
2) The A/C wasn’t as cold as it should be and they needed to replace the dryer – $790
3) The plastic components (bushings) of her suspension were cracking and they could fail if she hit a pothole – $825
4) Her fuel filter needed to be replaces – $325
5) They recommended a fuel injector cleaning – $350
6) Her tires were feathering and she needed a 4 wheel alignment – $350

I went online and found your instructions on how to replace the blower relay. It took 15 minutes to replace and cost $100 for the part. Everything works fine and all the other items were BS not to mention 2 to 3 times what they should be charging for the services.

For once crime didn’t pay.

Oh yeah I forgot, they charged her $135 to tell her how they were going to rip her off. I ordered the manuals yesterday.

Last edited by plockj; 07-19-2006 at 11:45 AM.

07-30-2006, 11:51 AM

Thanks for the great post! I was amazed at the detailed instructions on replacing the FSU.

08-04-2006, 02:40 PM

Thanks a million. Saved me a fortune. I hate to think what the stealership would have charged me. Regards UK member.

08-16-2006, 03:54 PM

Thank you. Saved me from replacing the climate control unit unnessarily (Had a similar problem on my E36 M3 that was the unit). After reading your description, I replaced the unit in under 15 mins with no fuss or drama. It really was nice knowing the details without having to go “diving” under the dash in 90 degree weather.


Residential Electrician, Electrician #are #you #in #the #dark, #are #you #in #the


#

Welcome to Our Site


We are strictly residential electricians. This means we know how to take care of your home in every way. We specialize in accent lighting, ceiling fans. kitchen remodels. bathroom lighting. can lighting, energy efficient lighting. attic fans. house wiring. and much more.

Our company cleans up like no other contractor you ve seen. We vacuum up any mess with our own vacuum! All our employees are cordial and trustworthy. We are a family company and we consider our customers to be our extended family. Your satisfaction with our service is our utmost priority. Our customers generally come to us through word of mouth and our phone rings constantly. Thank you for recommending us through the years and trusting us with your home.

We Provide Services to the Following Cities and Towns in CA:

  • Orange County, CA
  • Mission Viejo, CA
  • Irvine, CA
  • Woodbridge, CA
  • Turtle Rock, CA
  • Newport, CA
  • Newport Beach, CA
  • Big Canyon, CA
  • Balboa, CA
  • Monarch Beach, CA
  • Newport Coast, CA
  • Shady Canyon, CA
  • Laguna, CA
  • Laguna Beach, CA
  • Corona Del Mar, CA
  • Huntington Beach, CA
  • Seal Beach, CA
  • Long Beach, CA
  • Sunset Beach, CA
  • Los Alamitos, CA
  • Rossmoor, CA
  • Fountain Valley, CA
  • Costa Mesa, CA
  • Yorba Linda, CA
  • Orange, CA
  • Anaheim, CA
  • Anaheim Hills, CA
  • Tustin, CA
  • Tustin Ranch, CA
  • North Tustin, CA
  • Santa Ana, CA
  • Villa Park, CA
  • Rancho Santa Margarita, CA
  • Lake Forest, CA
  • Irvine Spectrum, CA
  • Foothill Ranch, CA
  • Coto De Caza, CA
  • Coto, CA
  • Dove Canyon, CA
  • Ladera Ranch, CA
  • Ladera, CA
  • Las Flores, CA
  • San Juan, CA
  • San Juan Capistrano, CA
  • Laguna Niguel, CA
  • Laguna Hills, CA
  • Trabuco Canyon, CA
  • Dana Point, CA
  • San Clemente, CA
  • Saddleback, CA
  • South Orange County, CA

Excellant work and very courteous. Thank you!

The team was very efficient and did a clean, professional job of installing our two ceiling fans. The did a great job of explaining the controls after installation. Great job!

Outstanding and professional service. will always recommend Armes Electric for any electrical work.

Jason and Juan did an absolutely flawless job installing can lights. They left no holes in the walls or marks on the ceiling – just two lights exactly where we asked that they be installed. Your workers always do an outstanding job.

Armes Electric provides you with these services, and More..

Kitchen/Bath Remodels
Recessed Can Lighting
Picture Lighting
Accent Lighting
Under cabinet Lighting
240 Spa Runs
Convenience/Holiday Outlets
Troubleshooting

We look forward to serving all of your electrical needs.

We are strictly residential electricians. This means we know how to take care of your home in every way. We specialize in accent lighting, ceiling fans, kitchen remodels, can lighting, attic fans, and much more. Our company cleans up like no other contractor you ve seen. We vacuum up any mess with our own vacuum! All our employees are cordial and trustworthy. We are a family company and we consider our customers to be our extended family. Your satisfaction with our service is our utmost priority. Our customers generally come to us through word of mouth and our phone rings constantly.